| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| 54ALS05 | 2535 | 现货库存 | DIP | 00+ |
|
||
| 54ALS05 | DIP | 6 |
|
 
|
|
54ALS05 Datasheet * Allparameters measured atTc=250C,nominalinputvoltage and full rated load unless otherwise noted. Refer to the CALEX Application Notes for the definition of terms, measurement circuits and other information. (1) Noise is measured per CALEX application notes. Measurement bandwidth is 0-20 MHz. RMS noise is measured over a 0.01-1 M Hz bandwidth. To sim ulate standard PCB decou pling practices, output noise is measured with a 10pf, tantalum and O.OlpF, ceramic capacitor located l inch away from the converter. Input ripple is measured into a 10pH source impedance. 54ALS05 Price *Per Port tFormerly LD-410 "Up t0 0.1% with thermoelectric ttFormerly LA-410 cooling to malntaln Tc at 250C 54ALS05 on stock Port o is an 8-bit open drain bi-directional I/O port. As an output port, each pin can sink eight TTL inputs. When Is are written to port o pins, the pins can be used as high-impedance inputs. Slave Address The first byte that the FM24CL16 expects after a Start condition is the slave address. As shown in Figure 4, the slave address contains the device type, the page of memory to be accessed, and a bit that specifies ifthe transaction is a read or a write. |
