| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| CDCR81DBQ | TI | SSOP-24 | 02+ | Own stock | 160 |
|
|
| CDCR81DBQ | TI | 160 | 02+ |
|
|||
| CDCR81DBQ | TI | 755 |
|
||||
| CDCR81DBQ | TI | SSOP | 05+ | parts are new & orig | 7 |
|
|
| CDCR81DBQ | TI | SSOP-24 | 02+ | 160 |
|
||
| CDCR81DBQ | TI | 99+ | New&Original | 755 |
|
||
| CDCR81DBQ | TI | SSOP-24 |
|
||||
| CDCR81DBQ | TI | 02+ | 160 |
|
|||
| CDCR81DBQ | TI | 160 |
|
|
CDCR81DBQ Datasheet Thermal resistances corresponding to other copper areas can be obtained from Figure 21 0r by calculation using Equation 2 0r 3. Equation 2 is used for copper area defined in inches square and equation 3 is for area in centimeters square. The area, in square inches or square centimeters is the top copper area including the gate and source pads. CDCR81DBQ Price
CDCR81DBQ on stock The spectral response of the G series devices is similar to that of other high-quality silicon photodetectors, covering the range from the near UV to the near IR. A glass window is standard; however, an optional quartz window is available. Relative spectral response is shown as a function of wavelength in Figure 4. Note that relatively high sensitivity is maintained even in the blue end of the spectrum because there is no interfering structure covering the diode. As most applications for these devices (OCR, fax, etc.) utilize visible light, the sensitivity and uniformity of response are specified using a source with the spectral distribution shown by the dotted line in Figure 4. This spec;tral distribution is produced by filtering a 28700K tungsten source with a Fish-Schurman HA-11 heat absorbing filter l mm thick.
The X28HC256 can be automatically protected during power-up and power-down (without the need for exter- nal circuits) by employing the software data protection feature. The internal software data protection circuit is enabled after the first write operation, utilizing the soft- ware algorithm. This circuit is nonvolatile, and will remain set for the life of the device unless the reset command is issued. |