|
|
| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| ERJ-L1WKJ50MU | panasonic | 2006 | SMD |
|
|||
| ERJ-L1WKJ50MU | PANASONIC | 07+ | SMD |
|
|
ERJ-L1WKJ50MU Datasheet Installation is simple and cheap. The Cig-Arrete~ is self contained and operates with four 'D' cell batteries readily available from any good retail outlet. ERJ-L1WKJ50MU on stock for three-wire operation. Gain settings, signal polarity and channel selection can be configured in software using the serial port. The AD7714 provides self-calibration, system calibration and back- ground calibration options and also allows the user to read and write the on-chip calibration registers. Vertical power DMOS switch Low on-state resistance 5 V logic compatible input with hysteresis Overtemperature protection - self resets with hysteresis Overload protection against short circuit load with output current limiting; latched - reset by input High supply voltage load protection Supply undervoltage lock out Status indication for overload protection activated Diagnostic status indication of open circuit load Very low quiescent current Voltage clamping for turn off of inductive loads ESD protection on all pins Reverse battery and overvoltage protection with external ground resistor R()JC appears in the package section ofthe data sheet. Like R()JA, it too is a function ofpackage type. R~cs and R()SA are functions of the package type, heatsink and the interface between them. These values appear in heat sink data sheets of heat sink manufacturers. |
