HI-8382JF，there are the best HI-8382JF suppiers all over the world here.These are the list and detailed contact method of HI-8382JF suppliers all over the world as follows.You can buy or get informations of HI-8382JF through email , message or tel.

suppliers of HI-8382JF and PDF data of HI-8382JF

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
HI-8382JF	HOLT	PLCC28	06+		54	ICON INTERNATIONAL (HK) CHIPS .. Contact:Lin Tel:86-755-23816108 Fax:86-755-23816109 Email: ruishengic@163.com
HI-8382JF	HOLT	PLCC28	06+	ORIGINEL	54	MTE ELECTRONICS CO Contact:Klien Tel:86-754-84484548 Fax: Email: mte668@gmail.com
HI-8382JF	54	ORIGINAL	HOLT		06+	TENCO ELECTRONIC CO. Contact:Kevin Tel:86-755-82546383 Fax:86 Email: tenco@tencoparts.com
HI-8382JF	n/a	PLCC28	n/a	NEW AND ORIGINAL To:	74	SunPlus Electronics co. Contact:David Tel:86-755-83677874 Fax:86-755-83677875 Email: david@sunplusic.com
HI-8382JF	54	NEW & STOC	HOLT		06+	Commercial(HK)Chips Co. Contact:susan Tel:86-755-83759984 Fax: Email: susan@commercialdz.com

HI-8382JF Datasheet

This mode is entered whenever a wake-up event occurs via the LIN bus or NWake pin while the TPIC1021 is in low power mode. The LIN bus slave termination circuit and the INH pin are turned on when standby mode is entered. The application system will power up once the INH pin is turn assuming it is using a voltage regulator connected via INH pin. Standby Mode is signaled via a low level on RXD pin. When EN pin is set high while the TPIC1021 is in Standby Mode the device returns to Normal Mode and the normal transmission paths from TXD to LIN bus and LIN bus to RXD are turned on.
HI-8382JF Price



		I12	v 5'c-
		{ + 0f	js--c- : io t- -
f	_ __ _	l Odr

HI-8382JF on stock

Parameter Conditions Min Typ Max Units
Power Supply Current	Off-Hook		10	15	mA
Transmit Insertion loss	600 0hm Impedance, 1000 Hz		2	4	dB
Receive Insertion loss	600 0hm Impedance, 1000 Hz		2	4	dB
Line Impedance	At 1000 Hz	540	600	660	ohms
Coupler Match input impedance	Input impedance to Tl & T2 for 600 0hm line impedance		340		Ohms
Ring Detect Sensitivity	Minimum Ring voltage detected as a valid ring signal		20	38	Vrms
Rl Output Voltage	Ring present at Tip & Ring		4.2		Volts
Loop Current Switch Control Voltage	OFF: (on-hook) ON: (off-hook)	2.0	3.0 0.2	0.5	Volts Volts
OH Control Current	Off-Hook		5		mA
Telephone Loop Current	Off-Hook	10		100	mA

Case Styles
	tOL..CW Ba Comi Cath Cath 0-247AC	,e non )de _2de ode

Suppliers Datasheet
		Exact Matc