| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| HS6043C | TI, | 01+, | 320, |
|
 |
||
| HS6043C | TI | TSSOP-14 | 07+ | 320 |
|
|
|
| HS6043C | TI | TSSOP-14 | 01+ | 315 |
|
||
| HS6043C | TI | TSSOP-14 | 01+ | 320 |
|
||
| HS6043C | TI | TSSOP-14 | 01+ | 410 |
|
||
| HS6043C | 03+ | email/MSN: eteasia@g | 720 |
|
 
|
||
| HS6043C | TI | TSSOP-14 | 01+ | 自己库存,需要请联系 | 320 |
|
|
| HS6043C | TI | TSSOP-14 | 01+ | NEW AND ORIIGINAL ST | 320 |
|
|
HS6043C Datasheet In applications where DC information must be passed through the filter, the output offset may be nulled out by varying the reference voltage. This will change the input trigger level and may require adjustment of clock voltage values. The reference input requires less than 1 00 UA of current and must always be well-filtered. A circuit that may be used to remove the output offset is shown in Figure 2. HS6043C Price
HS6043C on stock A current source with 25V output compliance and excellent ~tputimpedance can be obtained using this circuit. REF-01 ~keeps the line voltage and power dissipation constant in device ; the only important error consideration at room temperature is the negative supply rejection of the op amp. The typical 3pVN PSRR of the OP-02E will create an 8ppm change (3u\uvx 25\U10V)in output current overa 25V range. For example, a 10mA current source can be built (R = 1kfl) with 300Mfl output impedance. NOTE: (1) For detailed drawing and dimension table, see end of data sheet, or Appendix C of Burr-Brown lC Data Book. (2) The "B" grade will be marked with a "B" by pin 8. (3) The MSOP-8 is available on 7" tape and reel with 250 parts, and on 14" tape and reel with 2500 parts. For example, ordering 250 pieces of "OPA2658E-250" will get a single 250 piece tape and reel. Refer to Appendix B of Burr-Brown lC Data Book for detailed Tape and Reel Mechanical information. Figure 3 illustrates a typical automotive application scheme. The resistor Rs limits the input current of thedeviceand isthereforedimensionedconsidering the characteristics ofthe transientsto be eliminated. |
