| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| LCWW5SM-JXKX-4J8K | OSRAM | ROHS | 09+ | LED Supplier,QQ:3293 | 50000 |
|
|
LCWW5SM-JXKX-4J8K Datasheet I SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all semiconductor products fail with some probability. It is possible that these probabilistic failures could give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire, or that could cause damage to other property. When designing equipment, adopt safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective circuits and error prevention circuits for safe design, redundant design, and structural design. LCWW5SM-JXKX-4J8K Price O The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury ("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments. medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer's own risk. LCWW5SM-JXKX-4J8K on stock Linux A Linux driver is under development: please check the drivers section of the Pico Technology web site ( http://www.picotech.com/drivers.html ) for availability.
a) Example of the interface to the external controller ( Using the single ) After the RST signal from the external controller is input and then the internal circuit is initialized, each band data is output as shown below timing chart; Since the RD signal is output before each band is switched, the external controller is to count the rwrnber of the RD signal and is to recognize the status of the band and is to read the output data from the AOUT terminal through the external A/D converter. The output type of the external controller connected to the RST/CLKO terminal as the RST iriput should be the N-channel and open-drain type or the diode should be connected between the RST/CLKO terminal and the output terminal of the external controller, so that the voltage of the RST/CLKO terminal is not gotten over the Vss level. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
