TIMap-26  > MI-P7JZ-MYV

suppliers of MI-P7JZ-MYV and PDF data of MI-P7JZ-MYV

Part Numbert Mfg Packt D/C Descriptiont Qty Company/Contact  

MI-P7JZ-MYV Datasheet
#1 0utput voltage = (positive output pin voltage) - (negative output pin voltage) ;#2 0utput voltage differential l = difference in voltage between 400 mA source and 100 mA source from HIGH level output pin in forward or reverse mode >k3 0utput voltage differential 2 = difference in voltage between 400 mA sink and 100 mA sink from LOW level output pin in forward or reverse mode
MI-P7JZ-MYV Price
Notes: 5. Test conditions assume signal transition time of 3 ns or less, timing reference levels of l.5V, input pulse levels of O t0 3.OV, and output loading of the specified IOL/IOH and capacitance CL = 30 pF. 6. At any given temperature and voltage condition, tHZCE iS less than tLZCE, tHZOE iS less than tLZOE, and tHZWE iS less than tLZWE for any given device. 7. f :oE tldZCE: tHZWE.are specifIed with CL = 5 pF as in AC Test Loads. Transition is measured +500 mV from steady state voltage. 8. e'Tnternal write time of the memory is defined by the overlap of CE LOW and WE LOW. Both signals must be LOW to initiate a write and either signal can terminate a write by going HIGH. The data input set-up and hold timing should be referenced to the rising edge of the signal that terminates the write. 9. The minimum write cycle time for write cycle #3 (WE controlled, OE LOW) is the sum oftHZWE and tSD.
MI-P7JZ-MYV on stock
* This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operation sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods of time ma V affect reliabilitV.
EXAMPLE: A diode in this series is operated at a current of 7.5mA and has specified Temperature Coefficient (TC) limits of +/-o.oos%rc. To obtain the typical Temperature Coefficient limits for this same diode operated at a current of 6.OmA, the new TC limits c%rc) can be estimated using the graph in FIGURE 7. At a test current of 6.OmA the change in Temperature Coefficient (TC) is approximately-0.0006%.oC. The algebraic sum of +/- o.o05%o C and -0.0006%1'C gives the estimated limits of +0.0044%1'C and -0.00560/JC.