MW6IC2015，there are the best MW6IC2015 suppiers all over the world here.These are the list and detailed contact method of MW6IC2015 suppliers all over the world as follows.You can buy or get informations of MW6IC2015 through email , message or tel.

suppliers of MW6IC2015 and PDF data of MW6IC2015

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

MW6IC2015 Datasheet

PartNumber VDSS(V) rDS(o.)(l) EAS(mj)* ID(A)t IDM(A) POUT(W) atVIN(Vrms)

STR-F6624 450 0.92 204 16 19 98 100 130 120

STR-F6626 450 0.58 327 16 26 145 100 190 120

STR-F6628 450 0.35 647 22 36 225 100 290 120

STR-F6632 500 2.54 7.4 9.0 11.2 36 100 50 120

STR-F6652 650 2.8 126 7.9 10 40 85-265 86 220

STR-F6653 650 1.95 260 5.6 14 58 85-265 120 220

STR-F6654 650 1.15 399 9.7 18 92 85-265 190 220

STR-F6656 650 0.71 521 16 25 150 85-265 300 220

STR-F6672 900 7.7 163 4.6 6.4 25 (no heatsink) 220 50 (with heat sink) 220

STR-F6674 900 4.49 242 6.0 9.2 28 85-265 76 220

MW6IC2015 Price

			l		--	I I I I I I I I I I I I 750mA I I -l I r ~i - I I I I TI I OOmA

MW6IC2015 on stock

During normal operation, if Vcc voltage drops below 3.8V, the internal circuitry will go into power on reset again. The hysteresis helps decrease the noise sensitivity on the Vcc pin. After soft starts ends and during normal operation, if the converter output voltage exceeds 115% of the DAC output voltage, the LM2636 will lock into over voltage protection mode. The high side drive will be disabled, and the low side drive will be high. There are two ways to clear the mode. One is to cycle Vcc voltage once. The other is to toggle the OUTEN level. After the over voltage protection mode is cleared. the LM2636 will enter the soft start session and start

Note: 1. All blocks are protected at power-up, so the default configuration is 001 0r 101 according to WP status. 2. Current state and Next state gives the protection status of a block. The protection status is defined by the write protect pin and by DQl (= 1 for a locked block) and DQO (= 1 for a protected block) as read in the Autoselect instruction with Al = VIH and AO = VIL. 3. Next state is the protection status of a block after a Protect or Unprotect or Lock command has been issued or after WP has changed its_logic value. 4. A WP transition to VIH on a locked block will restore the previous DQO value, giving a 111 0r 110.

Suppliers Datasheet
		Exact Matc