| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
MX7524JCS MX7524JCS MX7524JCS Datasheet
MX7524JCS MX7524JCS MX7524JCS Price TI warrants performance of its semiconductor products to the specifications applicable at the time of sale in accordance with TI's standard warranty. Testing and other quality control techniques are utilized to the extent TI deems necessary to support this warranty. Specific testing of all parameters of each device is not necessarily performed, except those mandated by government requirements. MX7524JCS MX7524JCS MX7524JCS on stock This low failure rate represents data collected from Maxim's reliability monitor program. In addition to routine production Burn-In, Maxim pulls a sample from every fabrication process three times per week and subjects it to an extended Burn-In prior to shipment to ensure its reliability. The reliability control level for each lot to be shipped as standard product is 59 F.I.T. at a 60% confidence level, which equates t0 3 failures in an 80 piece sample. Maxim performs failure analysis on any lot that exceeds this reliability control level. Attached Burn-In Schematic (Spec. # 06-5514) shows the static Burn-In circuit. Maxim also performs quarterly 1000 hour life test monitors. This data is published in the Product Reliability Report (RR-1M). It is important to note that for most capacitors, ESR is speci- fied only at room temperature. However, the designer must ensure that the ESR will stay inside the limits shown over the entire operating temperature range for the design. For aluminum electrolytic capacitors, ESR will increase by about 30X as the temperature is reduced from 25'C to -40'C. This type of capacitor is not well-suited for low tem- perature operation. Solid tantalum capacitors have a more stable ESR over tem- perature, but are more expensive than aluminum electrolyt- ics. A cost-effective approach sometimes used is to parallel an aluminum electrolytic with a solid Tantalum, with the total capacitance split about 75/25% with the Aluminum being the larger value. lf two capacitors are paralleled, the effective ESR is the par- allel of the two individual values. The "flatter" ESR of the Tan- talum will keep the eective ESR from rising as quickly at low temperatures. |
