PAL20L1AV，there are the best PAL20L1AV suppiers all over the world here.These are the list and detailed contact method of PAL20L1AV suppliers all over the world as follows.You can buy or get informations of PAL20L1AV through email , message or tel.

suppliers of PAL20L1AV and PDF data of PAL20L1AV

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

PAL20L1AV Datasheet

Operation Power Monitor The ASM1834 supervisors simultaneously detect out-of- tolerance power supply conditions on both 3.3V and 5V power supplies. If the voltages at 5VIN or 3.3VIN are outside the tolerance band, the reset for the falling supply voltage becomes active. When the monitored supply returns to an in- tolerance state, the reset remains active for approximately 350ms before returning to the inactive state.
PAL20L1AV Price

FC	Function
L	Turn-ON interval
H	Dropout delay

PAL20L1AV on stock

Pin Name	Pin Number	I/O	Pin Description
AO-A14	1-10, 21, 23-26	I	Address. The 15 address lines select one of 32,768 bytes in the FRAM array. The address value will be latched on the falling edge of/CE.
DQ0-7	11-13, 15 -19	I/O	Data. 8-bit bi-directional data bus for accessing the FRAM array.
/CE	20	I	Chip Enable. /CE selects the device when low. The falling edge of/CE causes the address to be latched internally. Address changes that occur after /CE goes low will be ignored until the next falling edge occurs.
/OE	22	1	Output Enable. When /OE is low the FM1808 drives the data bus when valid data is available. Taking /OE high causes the DQ pins to be tri- stated.
/WE	27	I	Write Enable. Taking /WE low causes the FM1808 to write the contents of the data bus to the address location latched by the falling edge of /CE.
VDD	28	I	Supply Voltage. 5V
VSS	14	I	Ground.

	min	typ.	max	unit
Supply voltage range (+5 0C < Ta < +55 0C)	1.2	1.4	2.2	V
supply voltage range (-25 0C < Ta < +85 0C)	1.4		2.2	V
current consumption (normal operating)		600	1 000	IJA
current consumption ( Stand - by )		<1	1 0	pA
Switch current IPON ( VPON = ground )		-15	-50	IJA
Input voltage	3		100000	IJV
Input impedance of the RF amplifier		750		kl
Input impedance of the booster amplifier		95		kl
Output impedance of the RF seg ment ( A1 )		0.3		kl
Output impedance of the RF seg ment ( A2 )		7.5		kl
Amplification RF segment A1		53		dB
Range of input voltage booster amplifier	30		450	IJV
Internal resistance of the demod ulator		70		kl
Output voltage of the demod ulator		200		mVpp
Control time for CVi = 0.1 mV - 1 mV for CVi = 1 mV - 0.5 mV		0.8 5.0		S S
Output pulse width at transmitter pulse width =200 ms for VR = 1.4 V, ViE = 3 pV	1 80	1 95	220	ms

Suppliers Datasheet
		Exact Matc