| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| PAL22V10ACNT | . | . | . | 850 |
|
 
|
|
| PAL22V10ACNT | n/a | in stock | 09+ | IN STOCK/Talk to Ema | 34700 |
|
|
| PAL22V10ACNT | N/A | 34700 | 07+ |
|
|
||
| PAL22V10ACNT | N/A | 34700 | 07+ |
|
PAL22V10ACNT Datasheet
PAL22V10ACNT Price Figure 5. Test Circuit & Voltage Definitions for the Driver Common-Mode Output Voltage[3, 4, 5, 8, 9] Notes: 8. Voc measurement requires equipment with a 3-dB bandwidth of at least 300 MHz. 9. Allinput pulses are supplied by a frequency generator with the following characteristics: TR and tF " 1 nS; pulse re-rate = 50 Mpps; pulse width = 10 + 0.2 nS PAL22V10ACNT on stock CERTAIN APPLICATIONS USING SEMICONDUCTOR PRODUCTS MAY INVOLVE POTENTIAL RISKS OF DEATH, PERSONAL INJURY, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE ("CRITICAL APPLICATIONS"). TI SEMICONDUCTOR PRODUCTS ARE NOT DESIGNED, AUTHORIZED, OR WARRANTED TO BE SUITABLE FOR USE IN LIFE-SUPPORT DEVICES OR SYSTEMS OR OTHER CRITICAL APPLICATIONS.INCLUSION OF TI PRODUCTSIN SUCH APPLICATIONSIS UNDERSTOOD TO BE FULLY AT THE CUSTOMER'S RISK. Three Wire Interface. This full handshaking method allows complete flow control by the host at the expense of using two extra I/O lines. The host monitors the 'Data Ready' line (by polling or interrupt) until the NKM2401 signals that it has data in its buffer by setting the 'Data Ready' line low. When the host is ready to receive data, it must set the 'Send Data' line high. After a ImS delay (to allow settling) the serial data is sent. After each character is sent there is a further ImS delay and the 'Send Data' line is tested again. If it is still high another character is sent, if it is low no more characters are sent. This allows the host to unload the buffer a character at a time, process the data (at its own pace) and then collect another character. The 'Data Ready' line will only go high again when the buffer is empty. The only disadvantage to this method is that the NKM2401 cannot receive any more new messages until the buffer is empty. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
