PALEC16V8Q-25JC-4，there are the best PALEC16V8Q-25JC-4 suppiers all over the world here.These are the list and detailed contact method of PALEC16V8Q-25JC-4 suppliers all over the world as follows.You can buy or get informations of PALEC16V8Q-25JC-4 through email , message or tel.

suppliers of PALEC16V8Q-25JC-4 and PDF data of PALEC16V8Q-25JC-4

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

PALEC16V8Q-25JC-4 Datasheet

Notes: 1. Use an open-collector device with a loreakdown voltage of at least 10 V (preferably a discrete transistor) for the Inbibit* control input. A pull-up resistor is not necessary To disable the output voltage the control pin should be pulled low to less than +0.8 VDC.
PALEC16V8Q-25JC-4 Price

	I l cc-300V
F 1	I G J	t1 5 j1l z5'	1		ta tO	n-
				f1
		j		__f ir } I

					IT

PALEC16V8Q-25JC-4 on stock

(2) LiNb03 (lithium niobate) SAW filter: ...... TSF5xxx While the LiNb03 SAW filter has a high temperature coefficient of -72 ppm/ oC, it has a lower insertion loss by about 10 dB compared to the LiTa03 SAW filters. Therefore, matching on the output side of the SAW filter is not necessary. (Refer to Fig. 14.) In addition, because the insertion loss is low (although the ripple within the band is somewhat higher than in the case of the LiTa03 SAW filter), the low impedance and small feedthrough diminish the effects of peripheral circuit components and the pattern layout, and make it possible to stabilize the trap characteristics outside of the band.

Suppliers Datasheet
		Exact Matc