Q62702-P178，there are the best Q62702-P178 suppiers all over the world here.These are the list and detailed contact method of Q62702-P178 suppliers all over the world as follows.You can buy or get informations of Q62702-P178 through email , message or tel.

suppliers of Q62702-P178 and PDF data of Q62702-P178

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

Q62702-P178 Datasheet

~ Two part polycarbonate base and sealed body design allows easy 'first fix base' installation giving reduced chance of accidental damage during building works. , The body fits to the base by a simple 'push and twist' bayonet mechanism with integral seal. , Integral vandal resistant locking mechanism between the body and base which can be disabled if required. ~ Can be surface or box mounted and is compatible with side or rear cable entry. , User selectable 12V or 24V operation. ~ 1W nominal power. ~ Reverse polarity protection. , Fully protected to lP65 when installed. * Supplied complete with terminal block, O-ring seal and grommet. * Full installation instructions supplied. * Available in Red, Amber, Clear, Green or Blue lens colour options with standard white base.
Q62702-P178 Price

			Value
Parameter	Symbol	Conditions	Min	Typ.	Max	Unit
Current consumption	lcc	Vcc = 3.35 V, Vt = 1.7 V			6.0 6 .4*	mA
Frequency	fmin	Vcc = 3.35 V, Vt = 0.7 V			954.0*	MHz
Frequency	fmax	Vcc = 3.35 V, Vt = 2.7 V	980.0*			MHz
Control voltage sensitivity	kv	(fmax - fmin) / 2.0	18.0*	23.0	28.0*	MHzN
Oscillator output	Po	Vcc = 3.35 V, Vt = 1.7 V	-5.0 -6.0*	-2.5	0.0 1 .0*	dBm
		Vcc = 3.35 V, Vt = 1.7 V, Offset = 1 kHz, BW = 1 Hz	70.0*			dBc/Hz
		Vcc = 3.35 V, Vt = 1.7 V, Offset = 10 kHz, BW = 1 Hz	100.0*			dBc/Hz
C/N	C/N	Vcc = 3.35 V, Vt = 1.7 V, Offset = 30 kHz, BW = 1 Hz	110.0*			dBc/Hz
C/N	C/N	Vcc = 3.35 V, Vt = 1.7 V, Offset = 60 kHz, BW = 1 Hz	115.0*			dBc/Hz
Higher harmonics	Hs	Vcc = 3.35 V, Vt = 1.7 V, 2nd, 3rd			1 0.0*	dBc
Spurious	Sp	Vcc = 3.35 V, Vt = 1.7 V			-70.0*	dBc
Power supply variation	Push	Vcc = 3.35 V+0.25 V, vt = 1.7 V			+800*	kHz
Load variation	Pull	Vcc = 3.35 V, Vt = 1.7 V, VSWR = 2 ALL PHASE			+1000*	kHz
Temperature drift	Td	Ta = +25 IC +55 IC			+3000*	kHz

Q62702-P178 on stock

Output	106.25	106.25	120	125	125	125	150	155.52
Input		25	15	20	25	625	25	19.44
FB Divide Selection S[i:o]	HL	ML	HM	HL	MM	LL	MH	HM

SHDN~ (Pin 17): Shutdown Port l, Active Low. When pulled low, SHDNl shuts down port l, regardless of the state of the internal registers. Pulling SHDNl low is equivalent to setting the Reset Port l bit in the Reset Pushbutton register (lAh). Internal filtering of the SHDN1 pin prevents glitches less than l aS wide from reseting the LTC4258. Pull SHDNl high with "10k or tie to VDD. SHDN2 (Pin 18): Shutdown Port 2, Active Low. See SHDNl. SHDN3 (Pin 19): Shutdown Port 3, Active Low. See SHDNl. SHDN4 (Pin 20): Shutdown Port 4, Active Low. See SHDNl.

Suppliers Datasheet
		Exact Matc