| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
QBV850MINIEE Datasheet APPENDIX C. CM CONFIGURATION INTERFACE SPECIFICATION ........ ............... 127 C.l DHCP FIELDS USED BY THE CM ......... ............... 127 C.2 CM BINARY CONFIGURATION FILE FORMAT ..... ............... 127 C.3 CONFIGURATION FILE SETTINGS........... ............... 128 C.4 CONFIGURATION FILE CREATION.......... ............... 129 C.7 REGISTRATION CONFIGURATION SETTINGS ........ ............... 1 3 1 C.8.3 Downstream Frequency Configuration Setting.......... ............... 132 C.8.4 Upstream Channel ID Configuration Setting............. ............... 133 C.8.5 Network Access Control Object..... ............... 133 C.8.6 Class of Service Configuration Setting........ ............... 133 C.8.7 Modem Capabilities Configuration Setting................ ............... 135 C.8.8 CM Message Integrity Check (MIC) Configuration Setting..... ............... 136 C.8.9 CMTS Message Integrity Check (MIC) Configuration Setting ............... ............... 136 C.8.10 Vendor ID Configuration Setting................ ............... 136 C.8.11 Software Upgrade Filename.......... ............... 136 C.8.12 SNMP Write-Access Control......... ............... 136 C.8.14 Vendor-Specific Information ......... ............... 137 QBV850MINIEE Price
QBV850MINIEE on stock
Turn-On Time: Turning Qi in Figure 3-1 0ff, removes the low-voltage signal at pin 5 and enables the output. After a delay of approximately 10ms, the output voltage of a PT771x regulator rises to full regulation within 30ms 3. Figure 3-2 shows the typical output voltage waveform of a PT7711 following the turn-off of Qi at time t =0 secs. The output voltage in Figure 3-1 is set t0 3.3V by connecang VIDO (pin l),VID2 (pin 3), and VID3 (pin 4) to the 'Rem Sense Gnd' (pin 12)'. The waveform was measured with a +5V input source voltage, and 10-A resistive load. |
