RNP20S，there are the best RNP20S suppiers all over the world here.These are the list and detailed contact method of RNP20S suppliers all over the world as follows.You can buy or get informations of RNP20S through email , message or tel.

suppliers of RNP20S and PDF data of RNP20S

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
RNP20S	NA		02+	特价热卖	49	Shenzhen Wonderful Electronics.. Contact:Grace Tel:86-755-83987095 Fax:86-755-83987095 Email: boni@ic-afx.com

RNP20S Datasheet

The Output pin (pin 8) is intended to be connected to a virtual ground node, so that current flowing in it may be converted to a voltage (see Figures 2 & 15J. Choose the external opamp for good audio performance. The feedback resistor should be chosen based on the de- sired current-to-voltage conversion constant. Since the input resistor determines the voltage-to-current conver- sion at the input, the familiar ratio of Rf/Ri for an invert- ing opamp will determine the overall voltage gain when the 2181 is set for o dB current gain. Since the VCA per- forms best at settings near unity gain, use the input and feedback resistors to provide design-center gain or loss, if necessary.
RNP20S Price

SPECIFICATIONS
OUTPUT (Measured into a 50pF load connected with 4ft RG-11 cable)
Maximum Value	+10,000 Volts (VHicih - VLow)
Minimum Value	0 Volts
Means Of Adjustment	Controlled By Power Supply Input Voltages
Pulse Rise And Fall Time	<60ns (10% t0 90%)
Pulse Width	<200ns to DC, Controlled by Input Gate
Pulse Recurrence Frequency (PRF)	Single shot to >10KHz, Controlled by Input Gate cl)
Max. Average Power	100W (VHiah + VLow) (1)
Max. Duty Cycle	Continuous
Droop	<1%
Over/undershoot	<5%
Jitter	<1ns shot-to-shot
Output Connector	LEMO ERA.3S.415.CTL, Rear Panel
Output Cable	4 Ft RG-11
INPUT DC VOLTAGE +VIN (VHjqri)
Absolute Max. Value	+10,000 Volts
Absolute Min. Value	-10,000 Volts
Relative Max. Value	+10,000 Volts over VLow Voltage
Relative Min. Value	VLow Voltage
Input Connector	LEMO ERA.3S.415.CTL, Rear Panel
INPUT DC VOLTAGE -VIN (VLow)
Absolute Max. Value	+10,000 Volts
Absolute Min. Value	-10,000 Volts
Input Connector	LEMO ERA.3S.415.CTL, Rear Panel
GATE
Gate Source & Connector	+5V +1V int0 50Q, into front panel BNC connec- tor
VOLTAGE AND CURREN'	MONITORS
Voltage Monitor	2000:1 int0 50Q, BNC Connector
Current Monitor	10NV int0 50Q, BNC Connector
GENERAL
Input AC Power	90-240VAC 50/60Hz
Dimensions	19"W x 7.O"H x 21.5"D (48.25cm W x 17.8cm H x 54.6cm D)
Weight	Approximately 24 lbs (11 Kilograms)
SPECIFICATIONS SUBJECT To CHANGE VVTHOUT NOTICE

RNP20S on stock

Ceramic Capacitors Above 150 kHz the performance of aluminum electrolytic capacitors becomes less effective. To further improve the reflected input ripple current[2] or the output transient response, multilayer ceranuc capacitors can also be added. Ceramic capacitors have very low ESR and their resonant frequency is higher than the bandwidth of the regulator. When used on the output their combined ESR is not critical as long as the total value of ceramic capacitance does not exceed 300 pF. Also, to prevent the formation of local resonances, do not place more than five identical ce- ramic capacitors in parallel with values of 10 pF or greater.


	r		j
		7
/ VVA CNTRL - 2.7 V		f iA CNTRL -	1 7V
	I - 1 7-! iri VVA CNTRL - 0.7 V
			1

Suppliers Datasheet
		Exact Matc