| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
ROP1013008CR1A Datasheet The VFC1206 is a surface mountable flip chip resistor that utilizes Ultra Precision Bulk Metal~ "Z" Foil. This product differs from other Vishay Bulk Metal~ Foil surface mount devices in as much as it is installed with the foil side facing the PCB providing better power handling capabilities. The Foil element is isolated from the PCB by a protective overcoating. This overcoating plus the overall product design isolates the resistor from handling and installation stresses. The temperature coefficient of resistance (TCR) curve shown below compares the new revolutionary "Z" Foil with its TCR of < 0.5ppm/oC to the original Vishay "C" Foil. The Bulk Metal~ Foil characteristics of excellent long term stability, low noise and availability of tight tolerance are maintained in this Flip Chip configuration. The VFC1206 is available in any value within the specified resistance range. The flip chip configuration is more economical for high volume, anolog applications where high precision is required. ROP1013008CR1A Price
ROP1013008CR1A on stock
'1: VIN(max) and 10(max) are restricted by the relation PD(max)=(VIN-Vo).10=14(W). *2: Refer to the dropout voltage.(Refer to Setting DC Input Voltage on page 7.) *3: lsl is specified at -5(%) drop point of output voltage Vo on the condition that VIN=Vo+3V, 10=0.2A. *4: A foldback type overcurrent protection circuit is built into the IC regulator. Therefore, avoid using it for the following applications as it may cause starting errors: (1) Constant current load (2) Plus/minus power (3) Series power (4) Vo adjustment by raising ground voltage *5: Output is ON even when output control terminal Vc is open. Each input level is equivalent to LS-TTL. Therefore, it may be directly driven by an LS-TTL circuit. *6. When setting output voltage t0 5V or less, input voltage needs to be set t0 6V or over to operate stably. |
