RP05-2415DAW，there are the best RP05-2415DAW suppiers all over the world here.These are the list and detailed contact method of RP05-2415DAW suppliers all over the world as follows.You can buy or get informations of RP05-2415DAW through email , message or tel.

suppliers of RP05-2415DAW and PDF data of RP05-2415DAW

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
RP05-2415DAW	recompower	New origin	08+		500	HK United Electronics Dev.Ltd .. Contact:franken Tel:86-755-83633553 Fax: Email: franken@united-ic.com

RP05-2415DAW Datasheet

OR, IOR 24, 25 19, 20 21, 22 I Read inputs. When either ~OR or IOR is active (LOW or HIGH, respectively) while the UART is selected, the CPU is allowed to read status information or data from a selected UART register. Only one of these inputs is required for the transfer of data during a read operation; the other input should be tied to its inactive level (i.e., IOR tied LOW or IOR tied HIGH).
RP05-2415DAW Price

Writing a l to bit o of the configuration register starts the monitoring function. The device will perform a sequential sampling of all the inputs, starting with the internal temperature sensor and continuing with 2.5VIN, 12Vllxl, 3.3Vllxl, and VCC. If the master terminates the conversion, the sequential sampling will not stop until the sampling cycle is completed and the results are stored. When it starts again, it will always start with the temperature measurement.
RP05-2415DAW on stock

PARAMETER	bYMBOL	bUBGROUPS	MIN	TYP	MAX	UNIT
Write Cycle Time -20 -25 -30	twc	9. 10, 11	20 25 30			ns
Chip Select to End of Write -20 -25 -30	tcw	9. 10, 11	14 15 17			ns
Address Setup Time -20 -25 -30	lAs	9. 10, 11	0 0 0			ns
Address Valid to End of Write -20 -25 -30	tAW	9. 10, 11	14 15 17			ns
Write Pulse Width (OE High) -20 -25 -30	tWP	9. 10, 11	14 15 17			ns
Write Recovery Time -20 -25 -30	tWR	9. 10, 11	0 0 0			ns
Write to Output in High-Z -20 -25 -30	tWHZ	9. 10, 11		5 5 6		ns
Write Pulse Width (OE Low) -20 -25 -30	tWPi	9. 10, 11		20 25 30		ns
Data to Write Time Overlap -20 -25 -30	tDW	9. 10, 11	9 10 11			ns
End Write to Output Low-Z -20 -25 -30	tOw	9. 10, 11		6 7 8		ns

ltem		Svmbol	Condition	Min	Tvo	Max	Unit	Remark
		VDl-VS12		3.1	3.3	3.5	V
		VCC-VSS		0.95 (VDl-VS12)	VDl-VS12	1.05 (VDl-VS12)	V
Supply Voltage		VD2-VS12		2.97	3.0	3.03	V	Note.l
		VM-VS12			(VD2-Vs12)/2		V
		VDD-VSS		8.0		30.0	V
Input	H	VSH		0.9VD3		VD3	V
signal voltaqe	L	VSL		0		O.1VD3	v	Note.2
Frame Freq		1FRAME			70		Hz
Current		ID3	Ta=250C VD3-GND=3.3V VAA-GND=15.8V		(0.7)	(3.00)	mA
Consumption		IAA	VDl-VS12=3.OV VM-VS12=1.5V f FRAME=70Hz Duty=1/241 DF=13 Lines		(0.15)	(0.30)	mA	Note.3

Suppliers Datasheet
		Exact Matc