RPC1S150-J Datasheet VO = 1.4V, RS = 01 , 5V < vcc+ < 30V, OV < Vic < VCC+ - 1.5V The direction of the input current is out of the lC. This current is essentially constant, independent of the state of the output, so no loading charge change exists on the input lines The input common-mode ve signal voltage should not be allowed to go negative by more than 0.3V. The upper end of the common-mode voltage rea:glt.gVCfCe+'thl.r5VP~tts~gi{her or both inputs can go to +32V without damage. Due to the proximity of external components insure that coupling is not originating via stray capacitance between these external parts. This typically can be detected as this type of capacitance increases at higher frequences. RPC1S150-J Price| | | | | | | | | | | | | | Tj= | - 5e | ioC | | | | | | | | | | | | | | Tj= - 25C | | | | | | | | IiI - T. = 1fitloC - | | | | | | | | IJ | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
RPC1S150-J on stock| | | | 6150E | | | Items | Symbols | Conditions | -060 -080 | Units | | | C -LJ | VRRM | | 600 | 800 | V | | J | PL | VRSM | | 660 | 880 | V | | | | Io | 50/60HzTc -105 | 150 | A | | | IFSM | 9 | 1500 | A | | | 12t | 12t | b | 9000 | AZS | | | | Ti | | - 40+150 | | | | | TsLS | | -40125 | | | | h p | 1 | 1}M5 | 3.0 | N-m | | | | i1M6 | 4.0 | | | | | | 0 | G | | | | At - | AC2000V 1 | | | | | | 350 | g | | | | | | | |
| SYMBOL | PARAMETER | CONDITIONS | MIN TYP MAX | UNITS | | AVOL | Large Signal Voltage Gain | RL = 10k; -13.5V < VOUT < 13.5V RL = 2k; -13.5V < VOUT < 13.5V | q q | 1000 1600 700 500 1000 300 | \!lmV \//mV \!lmV \//mV | | VOL | Output Voltage Swing Low (Referred to VEE) | No Load ISINK = lOOccA ISINK = 1 mA | q q q | 25 65 35 75 130 200 | mV mV mV | | VOH | Output Voltage Swing High (Referred to Vcc) | No Load ISOURCE = lOOccA ISOURCE = ImA | q q q | 185 350 195 370 270 450 | mV mV mV | | Is | Supply Current per Amplifier | | q | 1.5 2.3 1.8 2.8 | mA mA | | Isc | Short-Circuit Current | VOUT Short to V- | q | 1 0 25 1 0 25 | mA mA | | VOUT Short to V+ | q | 1 0 20 1 0 20 | mA mA | | FPBW | Full Power Bandwidth (Note 7) | VOUT = 14Vp_p | | 9 | kHz | | GBW | Gain Bandwidth Product | f= 20kHz | | 0.8 1.1 | MHz | | THD | Total Harmonic Distortion and Noise | vo = 25Vp_p, Av = -1, f = 100kHz, Rf = 10k, BW = 22kHz Vo = 25Vp_p, Av = 1, f = lOOkHz, RL = 10k, BW = 22kHz | | 0.00029 0.00029 | % % | | SR+ | Slew Rate Positive | Av=1 | q | 0.25 0.4 02 | V/c6 j| | | SR- | Slew Rate Negative | Av=1 | q | 0.25 0.55 02 | j| \| | | | | | | |
|
