| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
SI9110AK-883 SI9110AK-883 SI9110AK883 Datasheet These are the reference voltage inputs. They may be placed at any voltage between GND and Vcc, but VREF+ must be greater than VREF-. An input voltage equal to VREF- pro- duces an output code of 0, and an input volt- age equal to (VREF - 1 LSB) produces an out- put code of 1023. SI9110AK-883 SI9110AK-883 SI9110AK883 Price
SI9110AK-883 SI9110AK-883 SI9110AK883 on stock A: Averaged over any interval of 30 seconds maximum. B: The light source is a tungsten filament lamp operated at a distribution tem- perature of 2856K. Supply voltage is 150 volts between the cathode and al other electrodes connected together as anode. C:The value is cathode output current when a blue filter(Corning CS-5-58 polished t0 1/2 stock thickness) is interposed between the light source and the tube under the same condition as Note B. D:Measured with the same light source as Note B and with the anode~to- cathode supply voltage and voltage distribution ratio shown in Table l be- low. E: Measured with the same supply voltage and voltage distribution ratio as Note D after removal of light. F: Measured at the voltage producing the gain of lX106. G:ENI is an indication of the photon-limited signal-to-noise ratio. It refers to the amount of light in watts to produce a signal-to-noise ratio of unity in the output of a photomultiplier tube. For batteries like lithium-ion that require accurate final float potential, the internal 2.457V reference, voltage amplifier and the resistor divider provide reg ulation with +1% (max) accuracy. For NiMH and NiCd batteries, the LTC1731 can be turned into a current source by pulling the TIMER pin to Vcc. When in the constant-current only mode, the voltage amplifier, timer and the trickle charge function are all disabled. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
