| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
SI9185DMP-12-T1 SI9185DMP-12-T1 SI9185DMP12T1 Datasheet
SI9185DMP-12-T1 SI9185DMP-12-T1 SI9185DMP12T1 Price Data for transmission is input to the CS8130 0n the TXD pin. The selected modulation scheme is then applied to the data, and the resulting signals are used to drive the LED. There are 2 LED out- put pins: LEDIC and LED2C. They are open drain outputs, which pull down to TGND or float. The LED is connected via resistors to both LEDIC and LED2C. The current level flowing through the LED is determined by the external resistors. Normally, LEDIC is used to drive the LED. If additional current is needed, (for exam- ple for TV remote operation), then the second driver may be enabled. The amount of 'boost' current is determined by the external resistor connected to the LED2C pin. SI9185DMP-12-T1 SI9185DMP-12-T1 SI9185DMP12T1 on stock Note : The curves of the figure 3 are specified for a junction temperature of 250C before surge. The given results may be extrapolated for otherjunction temperatures by using the following formula qVBR = a.T' (Tamb -25) ' VBR(250C). For intermediate voltages, extrapolate the given results.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
