An external hardware circuit connection needs to be made between the LD/PSmain and LD/PS aux pins and the loop filter (simplest configuration is to install a low-value resistor between each of the pins and the largest capacitor of the loop filter). These pins have three possible states. Under a locked condition, the state is high impedance. This allows the charge pump circuitry to control the VCO. During an out of lock condition, the pins drive high to VCC or low to ground, effectively steering the VCO. These pins actually toggle between high impedance and eitherVCC or ground at the comparison frequency rate during the out of lock condition.
SN65MLVD047APW on stock Please refer to the low pressure section for information on products with operating pressures less than 0-2 PSI. For an uncompensated sensor (Model 25) please contact the factory for additional information.
| Output voltage | 15.7V output |
| Output voltage precision:5% | PQ15RFIF |
| Output voltage precision:2.5% | PQ15RFIG |
| |
