STA389，there are the best STA389 suppiers all over the world here.These are the list and detailed contact method of STA389 suppliers all over the world as follows.You can buy or get informations of STA389 through email , message or tel.

suppliers of STA389 and PDF data of STA389

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
STA389	Sirenza				1010	Reputation(H.K.)Co.,Ltd Contact:Vicky Tel:86-755-82883352 Fax:86-755-82883354 Email: sales@sddz-ic.com

STA389 Datasheet

The MP111 has two ground pins (pins 3, 32). These pins provide a return for the internal capacitive bypassing of the small signal portions of the MP111. The two ground pins are not connected together on the substrate. Both of these pins are required to be connected to the system signal ground.
STA389 Price

PARAMETER	TEST CONDITIONS	MIN	TYP	MAX	UNIT
VOH High level output, GAT-SOURCE	SENSE = SOURCE	11	14	17	V
ISINK f GAT sink current in fault	SENSE - SOURCE = 80 mV, GAT = -43 V, FLTTIME = 5 V	30	75
ISINK_I GAT sink current in linear mode	SENSE - SOURCE = 80 mV, GAT = -43 V, FLTTIME = 2 V		5	10	mA
IIN SENSE input current	0.0 V < SENSE - SOURCE < 0.2 V	-1		1
VREF_K ~~f~rF~8cEe clamp voltage, SENSE -	RAMP - SOURCE = 6 V	34	42	50	mV
VIO Input offset voltage, SENSE - SOURCE	RAMP - SOURCE = 0 V	-7		9	mV

STA389 on stock

HOLD is used in conjunction with the CS pin to select the device. Once the partis selected and a serialsequence is underway, HOLD may be used to pause the serial communication with the controller without resetting the serialsequence. To pause, HOLD must be brought LOW while SCKis LOW. To resume communication, HOLD is brought HIGH, again while SCK is LOW. If the pause feature is not used, HOLD should be held HIGH at all times.

455 {11r+1

06211f7I-1

7 DIA J,52. (1 (11 NAL F 1248 DIA {3 17) 500 (suo~lD'A l DIA. MAX t12 70J MOUNTING SURFACE

Suppliers Datasheet
		Exact Matc