|
| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| TLC5917IPW | 41 | TI |
|
||||
| TLC5917IPW | TI | 09+ | 2,800 |
|
|||
| TLC5917IPW | TI | TSSOP | 02 |
|
 
|
||
| TLC5917IPW | TI | TSSOP | 07+ | Confirm Stock | 5 |
|
|
| TLC5917IPW | TI | 43 |
|
||||
| TLC5917IPW | TI | TSSOP | 2 | new original parts | 5 |
|
|
| TLC5917IPW | TI | 2008+ | 80 |
|
|||
| TLC5917IPW | TI | TSSOP | 07+ | 5 |
|
||
| TLC5917IPW | 5 | 07+ | TI |
|
|||
| TLC5917IPW | TI | 08+ | 2783 |
|
|||
| TLC5917IPW | TI | TSSOP | 02 |
|
|
||
| TLC5917IPW | TI | TSSOP | 02 |
|
|||
| TLC5917IPW | 43 | TI |
|
|
TLC5917IPW Datasheet There are 3 shift registers included in the design which can shift out of luminance and border dots to color encoder. The bordering and shadowing feature is configured in this block. For bordering eect, the character will be enveloped with blackedge on four sides. For shadowing eect, the character is enveloped with blackedge for right and bottom sides only. TLC5917IPW Price Description The RGR1622 is a high speed fiber optic receiver. It detects light in the 1200 - 1600 nm wavelength range and converts it to an electrical signal at data rates up to 622 Mbit/s. TLC5917IPW on stock COMMAND SEQUENCES: When the device is first pow- ered on it will be reset to the read or standby mode depending upon the state of the control line inputs. In order to perform other device functions, a series of command sequences are entered into the device. The command sequences are shown in the Command Definitions table. The command sequences are written by applying a low pulse on the WE or CE input with CE or WE low (respec- tively) and OE high. The address is latched on the falling edge of CE or WE, whichever occurs last. The data is latched by the first rising edge of CE or WE. Standard microprocessor write timings are used. The address loca- tions used in the command sequences are not affected by entering the command sequences.
1 For a high side switch, the load pin voltage goes negative with respect to ground during the turn-off of an inductive load. This negative voltage is clamped by the device. 2 The load current is self-limited during the response time for short circuit load protection. Response time is measured from when input goes high. 3 If the load resistance is low, but not a complete short circuit, such that the on-state voltage remains less than VBLOO), the device remains in current limiting until the overtemperature protection operates. |
