DRV (Pin 6): Drive Output Pin for the P-Channel MOSFET or PNP Transistor. The impedance is high at this pin, therefore,a high gain PNP pass transistor should be used. The DRV pin is internally clamped t0 8V (max) below Vcc.
Notes: 1. Under steady state (non-transient) conditions, IOL must be externally limited as follows: Maximum IOL per port pin: 20 mA Maximum total IOL for all output pins: 80 mA If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater than the listed test conditions.
. . . designed primarily for wideband, large-signal output and driver amplifier stages to 1 GHz. * Designed for Class A Linear Power Amplifiers * Specified 25 Volt, 900 MHz Charaaeristics: Output Power - 3 Watts Power Gain - 7.5 dB Min, Class AB ~ Gold Metallization for Improved Reliability
