| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| TMS320C6211PZ167 | 3500 | Texas Instruments |
|
 |
|
TMS320C6211PZ167 Datasheet Figure l shows the proposed buck and buck-boost converters. The rectifier circuit, which consists ofcapacitor C3 and diode D3, is in the front end for AC or DC input voltage. Then, the NCP1052 is self-powered up from the rectified input voltage directly with a Vcc capacitor C2. When the switch inside the IC is opened, there is a voltage across Drain (D) and Source (S) pins ofthe lC. If this voltage is greater than 20 V, an internal current source Istart = 6.3 mA (typ.) inside the IC charges up C2 and a voltage in C2 iS built up for the operation ofthe IC. Comparing to the switching frequency, the Vcc voltage level is in a lower-frequency 7.5-8.5 V hysteresis loop. This Vcc hysteresis loop is for frequency jittering features to minimize EMI and short-circuit fault timing function. TMS320C6211PZ167 Price I SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all semiconductor products fail with some probability. It is possible that these probabilistic failures could give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire, or that could cause damage to other property. When designing equipment, adopt safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective circuits and error prevention circuits for safe design, redundant design, and structural design. TMS320C6211PZ167 on stock
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
