| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| TMX320VC5404GGU | TI/BB | 08+ | New | 3740 |
|
|
TMX320VC5404GGU Datasheet Standby Mode The 27CX256 has two standby modes, a CMOS standby mode (when We CMOS devices are wired) and a TTL standby mode (when TTL level devices are wired). In the CMOS standby mode or power- down mode, the current consumed (lcci) is less than lmA. During TTL standby mode the current (Icc2) is less than 25mA, and the outputs 00-07 are in the high impedance state, independent of OE input. TMX320VC5404GGU Price Figure 3 shows typical connections to provide a nega- tive supply where a positive supply is available. A similar scheme may be employed for supply voltages anywhere in the operating range of +1.5V to +10V, keeping in mind that pin 6 (LV) is tied to the supply negative (GND) only forsupply voltages below 3.5V. The output characteristics of the circuit in Figure 3 are those of a nearly ideal voltage source in series with 70I Thus, for a load current of - 10 mA and a supply voltage of +5V, the output voltage would be - 4.3V. The dynamic output impedance ofthe TC7660H is due, primarily, to capacitive reactance of the charge transfer capacitor (Ci). Since this capacitor is connected to the output for only l/2 0f the cycle, the equation is: TMX320VC5404GGU on stock
Note: The 280 CMOS CPtJ (LH5080) is compatible with the 280 NMOS CPU (LH0080}. So there is no description here about the pins, CPU registers, architecture. interrupts, basic tim ings, and instruction sets. Refer back to the 280 NMOS CPU described earlier. |
|||||||||||||||
