TN8xC196KR，there are the best TN8xC196KR suppiers all over the world here.These are the list and detailed contact method of TN8xC196KR suppliers all over the world as follows.You can buy or get informations of TN8xC196KR through email , message or tel.

suppliers of TN8xC196KR and PDF data of TN8xC196KR

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

TN8xC196KR Datasheet

Parameter		Symbol	Ratings	Unit
Rating	Collector to base voltage	VCBO	50	V
of	Coliector to emitfer voltage	VCEO	50	V
element	Collector current	Ic	100	mA
	Total power dissipation	PT	150	mW
Overall	Junction temperature	Tj	150	C
Overall	Storage temperature	Tstg	-55 to +150	C

TN8xC196KR Price

SYMBOL	PARAMETER	CONDITIONS	MIN	TYP	MAX	UNIT
VFS IFSS	Flag 'low' Flag voltage Flag saturation current	normal operation IF = 1.6 mA VFS=10V		0.15 1 5	0.4	V mA
IFS VPSF V(CL)FS	Flag 'high' Flag leakage current Protection supply threshold voltage Flag clamping voltage	overload or fault VFS=10V VFF = 5 V; RF = 3 kl ; BUK106-50L BUK106-50S IF = 1 mA; Vps = 0 V	2.5 3.3 1 1	3.3 4.2 1 3	1 0 4 5	cCA V V V
RF	Application information Suitable external pull-up resistance	VFF =5 V VFF =10 V	1 2	1 0 20	50 1 00	l

TN8xC196KR on stock

1. The specifiedlimits represent the worst case values for the parameter. Since these worst case values normally occur at the supply voltage and temperatura extremes, additional noise immunity can be achieved by decreasing the allowable operating condition ranges. 2. Conditions for testing shown in the tables are not necessarily worst case. For worst case testing guidelines, refer to DC Testing. Chapter l, Secbon 3. 3. The speafied limits shown in the DC Electrical Characteristics table can be met only after thermalequilibrium has been established. Thermal equilibrium is established by applying power for at least 2 minutes, while maintaining transverse airflow of 2.5 meters/sec (500 linear feet/min) owr the device, mounted either in a test socket or on a printed circuit board. Test voltage values are given in the DC Operating Conditions table.

The T5754 is activated by ENABLE = H. PA_ENABLE must remain L for t >1 ms, then the CLK signal can be taken to clock the microcontroller and the output power can be modulated by means of Pin PA_ENABLE. After transmission PA_ENABLE is switched to L and the microcontroller switches back to internal clocking. The T5754 is switched back to standby mode with ENABLE = L.

Suppliers Datasheet
		Exact Matc