| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| TNPW12067K50DETAR2 | 100000 |
|
|
TNPW12067K50DETAR2 Datasheet ' PWN control input frequency is restricted by radiation condition Note 2 : Fault output is given only when the internal OC, SC, OT & UV protection. (only N side) Fault output of OC, SC protection given pulse. Fault output of OT, UV protection given pulse while over level. (OT is only N side) TNPW12067K50DETAR2 Price
TNPW12067K50DETAR2 on stock Aperture Delay is a measure of the track-to-hold switch delay time. It is the difference between the analog input amplifier's signal path delay and the digital track-to-hold switch delay. A positive delay indicates the digital switch delay is larger than the analog amplifier delay. 1.9 C,ID (Command/Data) ... Input This pin is used to identify whether serial or parallel data input is a command or data. When inputting a command set the C, ID pin to high. When inputting data, set to low. When inputting a command or data in the parallel interface mode, the command or data is latched at the second /STB rising edge. In the serial interface mode, the command or data is latched at the rising edge of the 8th /SCK. However, in parallel input, switching C, ID must be performed, before the falling edge of the lst /STB. When outputting data, C, ID input must always be set to low, regardless of whether the mode is parallel or serial. This is a Schmitt trigger input with hysteresis in order to prevent erroneous operation caused by noise. |
