WM-034BZ198K，there are the best WM-034BZ198K suppiers all over the world here.These are the list and detailed contact method of WM-034BZ198K suppliers all over the world as follows.You can buy or get informations of WM-034BZ198K through email , message or tel.

suppliers of WM-034BZ198K and PDF data of WM-034BZ198K

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
WM-034BZ198K	PANASONIC		N/A		50000	BONASE(HK) ELECTRONICS CO., L.. Contact:Vincent Tel:86-0755-82579312 Fax:86-0755-83239040 Email: bonase@vip.163.com
WM-034BZ198K	PANASONIC		N/A		50000	BONASE(HK) ELECTRONICS CO., L.. Contact:Vincent Tel:86-755-82579312 Fax:86-755-8323-9040 Email: bonase@vip.163.com

WM-034BZ198K Datasheet

Inductance Li serves to control the slope of the negative base current lB2 to recombine the excess carrier in the collector when base current is still present, this would avoid any tailing phenomenonin the collector current. The values of L and C are calculated from the following equations: L (/0)2 = C (VCEny)2
WM-034BZ198K Price

	Parameter	Typ.	Max	Units
RejC	Junction-to-Case		3.5
ROJA	Junction-to-Ambient (PCB mount)~		50	oc/w
ROJA	Junction-to-Ambient		110	oc/w

WM-034BZ198K on stock

The PDA is specified as 5% based on failures from group A, subgroup l, tests after cooldown as the final electrical test in accordance with method 5004 0f MIL-STD-883. The verified failures of group A, subgroup l, after burn-in divided by the total number of devices submitted for burn-in in that lot shall be used to determine the percent for the lot. Linear Technology Corporation reserves the right to test to tighter limits than those given.

TSSOP PIN	SYMBOL	BRIEF DESCRIPTION
1	DSO	Wiper Selection input for Up/Down interface
2	AO	Device Address for 2-wire interface
3	RWOB	Second Wiper Terminal of DCPO
4	NC	No Connect
5	NC	No Connect
6	U/D	Increment/Decrement for Up/Down interface
7	vcc	System Supply Voltage
8	RLO	Low Terminal of DCPO
9	RHO	High Terminal of DCPO
10	RWOA	First Wiper Terminal of the DCPO
11	A2	Device Address for 2-wire interface
12	WP	Hardware Write Protect (Active low)
13	SDA	Serial Data Input/Output for 2-wire interface
14	A1	Device Address for 2-wire interface
15	NC	No Connect
16	NC	No Connect
17	RWIB	Second Wiper Terminal of DCP1
18	VSS	System Ground
19	CS	Chip select for Up/Down interface
20	RWIA	First Wiper Terminal of DCP1
21	RH1	High Terminal of DCP1
22	RL1	Low Terminal of DCP1
23	SCL	Serial Clock for 2-wire interface
24	DS1	Wiper selection input for Up/Down interface

1 Vc-.= 10V


		ID 15~/

		¨A

Suppliers Datasheet
		Exact Matc